I am dealing with a leak in the lift arm seal and have already disassembled it to assess the situation. Upon inspection, the shaft and inner components appear to be in good condition. I have successfully removed the outer seal from the spool, but the manual indicates that there are additional sealing components underneath. I am seeking advice on the best method for removing these additional pieces - should I use a screwdriver to drive them out from the center, or is there a different technique that others have found effective? Any guidance on this matter would be greatly appreciated. Thank you, Norm.
When removing a stuck bearing or pulley, it is recommended to use an inside 2/3 jaw puller or a blind hole expanding puller if the sizes match closely. Avoid damaging the bore by trying to force it out with a screwdriver, as this could lead to additional issues. It is important to choose the right tool to prevent any complications during the extraction process.
happygolucky inquired about dealing with a leak on their lift arm seal, seeking advice on removing the inner seals from the spool. They were unsure whether to use a screwdriver to drive the seals out or if there was a better method. The issue seemed to involve one of the hydraulic cylinders that boom, with the wiper seal removed from the gland. It is recommended to cautiously remove the remaining seals inside the gland using a tool like an ice pick, being careful not to damage the gland. When installing new seals, heating them in hot water can make the process smoother, ensuring they are not damaged during installation. Consider purchasing installer tools for long-term maintenance of hydraulic cylinders in similar machines. Trusted sources such as local dealers or online platforms like eBay offer access to specialized tools for seal replacement.
Thank you for the information. I have read in the manual about the importance of heating the tools and the potential hazards of inserting them. I will be sure to look into acquiring those tools. Thanks once more. Norm.
I successfully disassembled the RAM with relative ease and ordered two kits. The only issue I encountered was when I tried to install the seal. After seeking help from a hydraulic expert, he quickly replaced the seal and handed the RAM back to me in no time. Having the right tools and expertise certainly makes tasks like these much simpler. I managed to put everything back together, and it is now working perfectly. Unfortunately, I damaged the outer seal, so I will need to get a wiper seal to replace it. I am considering taking the whole unit to the hydraulic expert for assistance. However, I did purchase a tool for any future maintenance needs. Have a great day! Norm.
It's truly incredible how a job can become so much simpler when equipped with the proper tools and just a bit of hands-on experience. The right tools and some know-how can make any job a breeze.
Answer: To remove the lift arm seals on a 1845 Case Skid Loader, you need to disassemble the components and carefully remove the outer seal from the spool. The manual may indicate additional sealing components underneath, which can be removed using a screwdriver to drive them out from the center.
Answer: If you notice a leak in the lift arm seal of your skid loader, it is advisable to disassemble the components to assess the situation. Ensure that the shaft and inner components are in good condition before proceeding with seal removal and replacement.
Answer: When removing additional sealing components under the outer seal of a skid loader, using a screwdriver to carefully drive them out from the center is a common and effective method. However, it is essential to proceed with caution to avoid damaging any components during the removal process.
Join hundreds of satisfied customers who have transformed their maintenance processes.
Sign up today and start optimizing your workflow.