Recently, I acquired an International 560 loader equipped with an IH817C engine that has a broken timing gear causing damage to the crankshaft key, valves, and pushrods. Unfortunately, finding replacement parts has proven to be quite difficult and costly. Considering the limited availability of parts, would opting for a Cummins engine be a reliable solution for this situation? Is it possible to install an 855 block in place of the damaged engine, and would the Cummins bell housing be compatible with the IH loader? Additionally, can the splined drive plate torque from the IH be attached to the Cummins flywheel? Any insights or advice on this matter would be greatly appreciated.
In the later 560s, the Cummins K series was implemented into the machinery. While there were some changes in engine mounts and hose connections, further investigation is recommended if you are determined to restore functionality to this equipment.
Answer: - Yes, it is possible to consider replacing the IH817C engine with a Cummins engine such as the 855 block as a potential solution due to the challenges in finding replacement parts for the original engine.
Answer: - While compatibility may vary depending on the specific models and configurations, it is advisable to check compatibility between the Cummins engine and the IH loader's bell housing to ensure a proper fit during the replacement process.
Answer: - It is important to verify if the splined drive plate torque from the IH loader can be attached to the Cummins engine's flywheel to ensure proper functioning and compatibility after the engine replacement.
Join hundreds of satisfied customers who have transformed their maintenance processes.
Sign up today and start optimizing your workflow.